|
羅德-施瓦茨公司SMIQ系列信號源的英文原版用戶操作手冊,詳盡地說明了SMIQ系列信號源的各種功能,測量操作設(shè)置和自動測量遠程控制等內(nèi)容.. Chapter 1: Preparation for Use Provides information on putting the unit into operation (AC supply connection,switch-on/off), functional test, preset settings, fitting the options and mounting the unit into a 19" rack. Chapter 2: Manual Operation Explains the manual control of SMIQ. It contains front and rear panel views,describes the control elements as well as connectors, provides a short introduction with sample settings for first-time users. It also explains how to change parameters and the use of the list editor and gives an overview of the menus for the functions covered by the unit and its options. It also presents the functions and menus of the unit and its options (frequency and level setting, analog and digital modulation, ARB, external modulation source AMIQ, fading simulation, noise generation and distortion simulation, BERT, sweep, LIST mode, memory sequence and general functions not relating to signal generation). Chapter 3: Remote Control Provides information on remote control of SMIQ. It informs about basics like IEC/IEEE bus, RS-232C interface, interface and device-dependent messages,command processing, status reporting system etc. It also includes an overview of each command system and describes all commands available in the unit and its options. Chapter 4: Maintenance Informs about preventive maintenance and functional tests. Chapter 5: Performance Test Contains information on how to check the rated specifications (required test equipment, test setup, test procedure) and on the performance test report Annex A: Interfaces Annex B: List of Error Messages Annex C: List of Commands Annex D: Programming Example |